Switch Puller Mod

Also saw that problem on the edges of the case with hotswap boards.
Didn’t know it could still work by shortening the legs, thanks a lot for the tip!

1 Like

Would it not be enough to grind one down?

You can grind down one side and it will work! I did one side at first and confirmed it was okay before doing the other side.

The final version is shown below. Besides grinding the tops used a hair tie band to keep it from opening too much and electric tape on the ends to prevent scratching plates. The electric tape will eventually wear down after a couple hundred switches. However it gives reassurance that I won’t scratch anything allowing for faster work.

10 Likes

You know what I hate? I hate switch pullers. :stuck_out_tongue:

I own a few. They all have issues. The RAMA one is my least favorite. I have 2 of them. They both are designed in a way that seems to promote ripping the top hosing off of my switches more often than pulling the switch from the keyboard.

Believe it or not, this one is superior in performance.

I have learned a certain way to hold it over the years that makes it even easier to use. It definitely works better for me.

7 Likes

Nice. What’s your trick to how you hold it?

This is the shape I keep it in. A bit different than when it was new.

I place my index finger through the tool and squeeze with my thumb and side of middle finger

9 Likes

Very clever. Thx!

Nice! I haven’t tried that one but I will give it a shot next time I order supplies.

Ooo I have one similar that I’ll have to try and shape that way.

thanks for the recommendation! I really hate the rama one too

Just wanted to say thanks for this post - I similarly modified my puller and the process of using it is so much more smooth now.

I didn’t shorten my tines quite as much, but just enough to squeeze them between the switches and the case of my tester board comfortably. I also gave them a good smoothing - my Chinesium distant imitation of a Dremel was finally useful for something!

2 Likes

Interesting - I had the opposite problem!
The tool that came with my keyboard just flat out didn’t work on the Gateron optical switches - the tines aren’t long enough. I actually cut myself trying.

I reverted to an unmodified IC puller, and it works a treat - instant results, next to no force required.

Customizing the Switch Puller to make it “yours”

Mini Guide:

Shoutout to ZapCables for:
1: Having all the parts to do this and a huge amount of options
2: Awesome customer service they are flexible, with reasonable requests, and very helpful!

13 Likes

This is the way. I have spoken.

2 Likes

That’s pretty neat.

Why not use the sleeve over the insulation?

The shrink tube is there so the paracord/tech flex don’t fringe up (is that the English word for it?) / make it look nice and tidy.

1 Like

“Fray” is the word - but that does get the point across.

1 Like

Blast from the past, I love these things and stash them in my workbench and desk for those tinkering times!

If you are referring to the rubber insulation (usually green or red) the standard tech flex or mdpc-x used for custom USB cables does not easily fit over it.

Even if it did it would make the puller very thick especially with the heat shrink that @skepp mentioned. Could make it tight when trying to remove some switches.

I think you misunderstood my question. I’m saying, instead of stripping the original insulation, just sleeve over it. Btw, it seems like MDPC Sata cable size would work on this, am I right?